Jump to content
Vari-Lite Controls Support Forum

Recommended Posts

Posted

hi I need wheel/opto/hall new wheel, my middle wheel stopped working, i have swapped the connectors over and the fault moves so I know its the wheel  board failed, (tested all the connectors and all continuous and tried it in other positions so I think i have covered all possible problems.

Any ideas where to get a spare part, board or complete wheel board cable?

Thanks Dave

Posted

Hi Dave,

Welcome to the Zero 88 Forum. 

24 minutes ago, davelowe said:

Any ideas where to get a spare part, board or complete wheel board cable?

Please drop us an email to support@zero88.com, and we’ll be able to let you know the availability. 

(I have deleted your duplicate post in the FLX S Forum).

If you have any questions let us know. 

Edward

Edward Smith
Formerly: Zero 88 Product Specialist - Email Support
Currently: Obsidian Control Systems Product Specialist

Posted

Dave,

            If you can release the middle wheel from the front panel - check the small PCB on the side of the wheel is locked in place under the clips. Sometimes the PCB comes adrift slightly and the electronics don't read the wheel movement - click it back in to place and it should be OK. I've rarely known these to fail to be honest.

If you do need to replace - I have some good used encoders for sale - you can find my website under my profile or search "The Service Guy".

Ian Knight aka The Service Guy - www.serviceguy.co.uk

  • 2 weeks later...
Posted

thanks, it is the board, I am pretty sure of that, I swapped it out with another working board to the same wheel and the wheel was ok.

I also checked the small resistor on the board as i know that these can be a bit flakey but that was ok as well.

Dave

Posted
On 11/17/2020 at 8:15 PM, davelowe said:

thanks, it is the board, I am pretty sure of that, I swapped it out with another working board to the same wheel and the wheel was ok.

I also checked the small resistor on the board as i know that these can be a bit flakey but that was ok as well.

Dave

If you let me know the PCB number of the board - I'm at my workshop on Friday & I'm pretty sure I should have one in my recovered spares stock, I'll have a look and check.

Ian Knight aka The Service Guy - www.serviceguy.co.uk

Posted
19 hours ago, davelowe said:

thanks mate sent me an old wheel today and it works fine, so all repairs now complete, but have but ya name in me boook

thanks Dave

Yay - result! Glad you got sorted :)

Ian Knight aka The Service Guy - www.serviceguy.co.uk

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.