Jump to content
Zero 88 Community Support Forum

Leap Frog 96 zerOS 7.9.6 DMX output stuck while changing submaster page


Recommended Posts

Hi there,

hope, anyone can help me with this problem:

I use a Leap Frog 96 with actual zerOS 7.9.6

I set up a simple tilt move effect with 4 moving heads, connected to DMX universe1, using DMX out on the desk.

The effect runs very smooth and stable until I do the following:

- change the page of the submasters

- change the page of the MFKs

- change the MFKs section

- do any other change that results in a rewrite of LCDs

the DMX output stucks for a short while, until page setup has finished and LCD write has finished.

I also tested this behaviour with an effect-based shutter chase and a chaser-based Tilt move.

I do not have any problems while changigng pages, if there is no change on LCD. For example change submaster bank without any submaster named or used.

So I came to the conclusion, that writing to the LCDs does disturb continous calculations and/or DMX output for a short while.

After searching in the forum a lot I think, there is no difference between Leap Frog and solution hardware.

So what is my problem?

Actual I can't use the desk for a show, because almost every user action does disturb the output.

I have this problems also with earlier versions of zerOS.

Many Thanks for Your help!

Dirk

Link to post
Share on other sites
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.