patch problem

[daniloT]

Hi

I have a problem on FLX48, I do not know if it comes from the patch or spots. after having patched 3 spots showtec performer RGBAL 2000, I light them one by one; and when I turn on the 2 the 1 is strobe, when I turn on the 3 the 1 and the 2 are put there. Can someone help me please?

[Edward Z88]

Hello,

Can you confirm the mode and the patch on the fixtures match the settings on the console?

Edward

[daniloT]

Mode Channel

All in inverse 1

Spot 1 adress 1 et fader 1

Spot 2 adress 9 et fader 2

Spot 3 adress 17 et fader 3

Thanks

 

[Edward Z88]

Hello,

Can you confirm they are set to the 8 channel HSIC mode?

If you are patching your fixtures manually, I would recommend disabling RigSync. To do this tap SETUP -> Universes -> RDM -> RigSync -> Disabled.

If you have any questions let me know.

Edward

[daniloT]

Hi 

I confirm i put 8 channel.

I disabled rigsync before i patch. There do again.

Thanks for begin answer

[Erics]

Check the DMX Output Window, witch values are send to the spots. Try to switch the dmx adresses of spot one and spot two and see if the error switch with your adress change. if the same spot is strobing, its a lamp / mode problem. If the error is than one spot one, it could be a patch or flx problem. So you can see if it's the lamp , the desk, or the patching in the flx.