Identifying effects on playbacks

[stowedout]

Hi Folks,

See attached photo. I have chosen a group of LED washes and on my external monitor I can see the current setting for each fixture in the group. Playback 6 introduces a colour cycle to the fixtures. where do I see how this colour cycle is being generated? I expect it's an effect but where do I see what effects are attributed to each playback? (interestingly when playback 6 introduces the colour cycle the visible current fixture colour settings don't appear to change on the monitor )

Cheers

Chris

[Edward Z88]

Hi Chris,

The parameter table shown at the bottom of the Output Window in your screenshot, should show you whether an effect is running or not. You will see the effect palette number written instead of a value percentage for the parameters included in the effect.

In your screenshot, cue 1 in playback 6 is displayed as yellow, meaning it hasn't yet been triggered. If you would like to preview this cue, make sure that you are viewing its playback, and then tap "Preview" at the bottom of the Output window. Selecting the fixtures included in this cue will then open the parameter table to show you what levels parameters are at, and whether any effects are included.

Any queries let me know,

Edward

[stowedout]

Thanks Edward I will give that a try. (as you pointed out at the time I took the photo the cue was not triggered)

Chris

[van den abbeele Eric]

Hello Edward

 

Can you tell us more about displayed color signification ? 

This can certainly explain some problems or How thing works ?

 

Thank a lot 

 

Eric

[Edward Z88]

Hi Eric,

The article below goes through all of the different colours and symbols shown in the Output window, and what they refer to...

http://support.zero88.com/1011707591

If you'd like further information on this just let me know.

Edward