Jump to content
Zero 88 Community Support Forum
marcopolo

Problem creating My own LED strip fixture

Recommended Posts

Hi. I am using the fixture editor to create my own fixture. I have a very simple LED controller. it has 8 channels and controls two separate LED strips.

It has 8 channels, and I have set up one virtual to dim. Two problems:

A) I can get one strip on the colour picker but not the other. Is there any way to have two colour pickers for the one DMX address?

B)A would be fine if I could get the two strips to operate as one. But this is also out of reach!

I have had several test runs - how do I delete the incorrect .ift files from the FLX

Thanks - Mark

LED Strip 5.ift

Share this post


Link to post
Share on other sites

Hi Mark,

Currently a fixture can only have one set of RGB control applied to the colour picker. If you require both to be, I would advise making a fixture for the first set of RGB, and patch 2 of them sequentially to control the fixture. 

To Clear unwanted .ift user fixtures, tap SETUP -> Clear Options -> Clear User Fixtures. 

Hope that helps

Edward

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.