Simonkbike Posted November 21, 2016 Report Share Posted November 21, 2016 Evening, Location is a village hall, mainly traditional lanterns on 4 lighting bars, bank of Chilli dimmers (one=12x; one=24x; 1=4x), all controlled through a Solution desk. The 4 channel box provides a switched supply (no dimmer) to a socket at each bar; i.e. with a dmx signal >0, the power is on. I don't have access to the original installation specs but it was circa 2010. Q1: I checked that the dimmer law is showing "normal" so can I assume that these are the "bypass switches" on the Chilli product range rather than dimmers? How else would I confirm this? The problem is that I need to use this to power the couple of LED fixtures we have, with the result that every fade to blackout powers the LED off/on causing a brief flash. I know it would be best to provide separate permanent power supply to the lighting bars, but with no budget it ain't going to happen, so I have to work with the feed through the Chilli boxes. My current thought is.... Q2) Can I remove the DMX control from a single channel and switch the power directly on/off at the Chilli box? I read the Chilli manual (but I quickly got lost) and tried setting a channel to manual, level=100 to no effect (the Solution desk remained the only way of switching the channel), so if anyone can provide step-by-step instructions, that would be great. New to this stuff so any alt suggestions welcome (apart from re-wiring!) S. Quote Link to comment Share on other sites More sharing options...
Jon Hole Posted November 27, 2016 Report Share Posted November 27, 2016 Hi Simonkbike, The Chilli 4 is a "HF" rack - that means it has 4 x relays and also 4 x 0-10v dimming, which combined are used when dimming fluorescents and the like. It sounds like your installation has used this just to provide 4 relay channels, and they're just ignoring the 0 - 10v, which is quite common. Therefore, you should be able to go into manual, like you say, and turn them to full to turn them on. I don't see a logical reason why that wouldn't work, so I'd first suggest you try that again on the 4 channel unit. Another option would be to simply record those 4 channels onto a submaster, and leave that submaster at full. The only things that could then affect those channels would be the 4 channel faders (maybe tape over them?) and the grandmaster (other submasters / cues wouldn't be able to affect them). An even better option would be to patch 4 "video" channels (there is a video channel fixture in the patch library under "standard fixtures") to those 4 addresses, and record that those at full onto a submaster. Although it sounds strange, because video channels are beamshape parameters rather than intensities, they aren't affected by the grandmaster / blackout button, and because they'd be a fixture, it's far harder to select them and wheel the parameter up/down by accident compared to just touching one of the faders. Hope this makes sense? Quote Jon Hole Global Product Manager, Systems and Control Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.