daoops Posted March 12, 2004 Report Share Posted March 12, 2004 I had a show today, and during programming everything seemed ok. But at last minute check, I tried out the fixtures and they had changed position. Only 1 of the four fixtures had changed it's position. And this happened in 3 of the programmed memories. Quote Link to comment Share on other sites More sharing options...
felixgeiger Posted March 13, 2004 Report Share Posted March 13, 2004 had the same problem. it's all better since i updated the firmware of the scanners. in my case they were martin mx-10 and the newest update is 1.5 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.