Jump to content
Zero 88 Community Support Forum

Problems with Betapack3

Recommended Posts



I have a problem with one of our betapack3. Only channel 1 works, the rest is dead.. I have tried to manual run the channels but it still don't work..


I have also tried to reset the dimmer by holding down up and down arrow, but no response..

What to do?



Share this post

Link to post
Share on other sites

hi andre,


please could email on the address below the units serial number found on the rear of the unit.

also can you confirm if the unit is running on single of three phase.

Are you also able to change to all modes in the unit or just manual mode?

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.