Jump to content
Vari-Lite Controls Support Forum

Betapack 3 Channels 1 & 2


macaw

Recommended Posts

Our church purchased three Betapack 3 units about 18 months ago. Until recently they've worked absolutely fine however last week we noticed a problems with channels 1 and 2 on one of the units.

 

When fading up the channels the lamps would suddenly jump to full brightness rather than fading up smoothly. When set to anything less than 100% the lamps would flicker, plus there seemed to be some sort of interference between the two channels - when one channel was faded up it caused the other to flicker for example. I'm fairly certain the fault is with the dimmer rather than the board, infact on one occasion when I had shut the board down before going to turn off the dimmer packs the lamps on one of the faulty channels suddenly randomed flashed on and off!

 

I would be very grateful for any advice.

 

Phil

Link to comment
Share on other sites

Hi Phil,

 

That sounds like a fault with a component in the dimmer sync circuit for that pair of channels.

Can you PM on the address below with the unit serial number so we can take this further.

Regards,

Keith Rogers

Zero 88 Support: support@zero88.com

Link to comment
Share on other sites

  • 1 year later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.