Jump to content
Vari-Lite Controls Support Forum

Fat Frog Start Up Problem


pbirkenshaw

Recommended Posts

I am using a Fat Frog that has developed a strange problem when it starts up. The desk boots up OK but when start up is delete it goes into the following state:

 

Black out active.

Wide mode on.

Both LEDs next to the Preset Control button are on (something that should not be possible)

External screen locked to memory view.

All displays have illumination set to zero so they appear blank.

 

The end result is that the desk is effectively locked and will not do anything; however, it can be unlocked by going through the following process (please don't ask me how I worked this out):

 

Press and hold the Wheel Group button while pressing the Preset Control button. This makes the Preset Control LEDs act normally with only one being on at a time.

Switch off black out

Leave wide mode on.

Press and hold F1 to unlock the external screen.

Use superuser to change screen illumination settings.

 

Then the desk operates normally as far as I can tell.

 

What I would really like to know is what is going on so any suggestions would be greatly appreciated.

 

Just to add an extra level of complication, this issue first appeared a few years ago when I switched the desk from full to partial memory mode. The issue was present until Christmas last year when all of a sudden everything went back to normal for no apparent reason. However, with similar lack of warning or reason, the problem has just reappeared.

 

I have replaced the battery in the desk in case this was the problem but it made no difference. The desk is also running the latest version of the operating system.

 

I look forward to hearing any suggestions!

 

Thanks for your help.

 

Paul

Link to comment
Share on other sites

Initial reaction would be a flat battery but you have indicated you change the battery recently.

When you did this do you carry out a reset desk once you change the battery.

 

Could you PM on the address below with the desk full serial number to take this further.

Regards,

Keith Rogers

Zero 88 Support: support@zero88.com

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.