jester777 Posted April 25, 2013 Report Posted April 25, 2013 I have a Fat Frog running the latest software controlling 2 MAC 250 Wash units. Everyting has worked fine for several years, until today. I upgraded to the 10.2 software this morning. Now I cant control the movers. Fixture 1 has starting address of 50 and fixture 2 starts at 70. This has been the setting since day 1 with no problems. I go into superuser and see in the patch screen that these values match what is set in the light. The only contrlol I have is when i use the postion wheel the colors change ont the Martins, beamshape and brightness work as well, nothing else works, not even home. Any thoughts? I have limited knowledge!Thanks!Daron Quote
jester777 Posted April 25, 2013 Author Report Posted April 25, 2013 Problem solved.....did not load correct profile. I had MAC 250 wash, not extended mode selected. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.