Jump to content
Zero 88 Community Support Forum
Sign in to follow this  

UDF settings

Recommended Posts

I am using the desk on a show this week. third time out but oddly the first time I have actually run a show with it.

My question is. What should I have set on the UDF for the following scenario.

I have a playback main stack. the show has LEDS and Mac 250s all programmed in and working fine. However I want to manually add two thrust stage areas (conventional lights), up and down as required. The problam is at the end of the manual part on pressing next on the master output the thrusts if on at all surge to 100 % and then fade. My workround has been to decide the maximum I require for the lighting on thrusts and set the UDF at say 60%. Then when I press next on the master they dont flash up but fade with the rest of the lighting. I have tried all the LTP and HTP settings, but with no luck. Any ideas chaps?

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  


Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.