Jump to content
Vari-Lite Controls Support Forum

y axis and offset


jesterfish

Recommended Posts

Hi. just got back from gig using a friends fat frog being familier with setting up submasters with basic scenes chases etc

i got a bit annoyed when i set up a forward sweep i ie: scanner beams start at back travel forward and then back and repeat ( y axis )

 

i found that the beams would go 2 one way 2 the other when i entered the speed option ( offset at zero) also set to Relative mode.

in manual tilt mode all scans set the same ( no reverse tilt or pan )

 

im assuming there must be a preset that needs altering as my f/frog will do a forward sweep no problem

 

thanks jesterfish

Link to comment
Share on other sites

HI . thanks for reply i will try that on wed i had noticed that offset was input at 10 % increment and zeroed them before start

also the offset reset itself when trying to reprogramme same effect could this be a preset done with the fixture editor ? although i think this unlikely as

fal 2000 are in the fixture library as a choice so no need to set a custom profile

 

thanks for your reply. Rich

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.