Chilli 12, 24 racks some channels not receiving DMX

notranati · February 24, 2009

Hello good people of the forum,

My problem is that on each phase I have some channels that do not receive any signal?

On phase 1 they are 9 - 12 (last four)

phase 2 they are 21 - 24 ( last four)

and phase 3 they are 25 - 35 ( every one except the last )

I have reset the dimmers and checked the DMX start address which is set at 1 for the 24 and 25 for the 12. But still no answer!!!!

I thought I could use a soft patch to circumvent the issue but to no avail.

Some people seem to think I have a busted transformer but before I have to shell out money I thought I would get some advice.

Thanks in advance

Chris

**KWR88** · April 2, 2009

Hi Chris,

think we have already spoken about this.

If you still have an issue please contact me on the e-mail address below.

Recommended Posts