How to connect a XLS to a DateQ Dimmer

[Withaar]

I have a XLS and 2 DateQ 603 Analogue 0-10v Dimmer.

The XLS uses a Din 8 and the Dimmer a 15 pin connector.

 

The XLS side (picture from the German manual)

 

The dimmer side:

 

1-6 = channel 1-6, 7=gnd, 8 = 15 Volt out, 9-15 not used.

 

Channel 1-6 is clear 1-6 to 1-6.

XLS Pin 8 = 0 V Signal Ground to Dimmer pin 7 = Gnd.

 

But do I need to connect XLS Pin 7 = Power IN, +20 Volts @ 200mA to Dimmer pin 8 = 15 Volt out ?

Why power IN and Out and how about the 5 volt difference and what about the 200mA?

And 20 volt, 15 volt... where are the 10 volt from 0-10 volt...?

[Paul]

The XLS does not have any internal connection to Pin 7 on the analogue output DIN connectors - the information in the German manual is incorrect on this point. You only need to connect channels 1-6 and 0V to the dimmer.

 

The correct information is given on the rear panel of the XLS:

[Withaar]

Thanks