zmx Posted August 24, 2006 Report Share Posted August 24, 2006 hallo, I need a little help with an old Delta5 installation. 2 Delta5 are used as simple analog switches connected to the mercury motor buttons (each channel is switched using one motor button) My problem is, that it is just a simple installation with small loads. 1. 4x25W UV (power-safe neon bulb? don't know the english word) 2. 4x15W ministrob 3. 1x12V/25W AC Transformator 4. 1x12V/10W AC " 5-8 should be used to switch some basic effects like strobs or moonflowers the problem is that the delta gives enough power to switch these parts on without beeing switch on. I have read about the neon installation with the 100K resistor used in the output circuit, but that doesn't help. I have also read about a preheat option, but couldn't locate any more information. Any hint how to fix this problem - thanks (I find out connecting a standart bulb parallel on each channel the unswitched basic power is dropped down, but then the UV bulbs beginn flickering) Quote Link to comment Share on other sites More sharing options...
KWR88 Posted August 24, 2006 Report Share Posted August 24, 2006 I think that the delta's may have developed another fault that is causing the analogue inputs to float regardless of the incomming control signal. I will PM you with a couple of things that you may be able to try. Quote Regards, Keith Rogers Zero 88 Support: support@zero88.com Link to comment Share on other sites More sharing options...
regi Posted September 18, 2006 Report Share Posted September 18, 2006 hi! can you post those things here too, or maybe send me a pm also? Quote Link to comment Share on other sites More sharing options...
KWR88 Posted September 19, 2006 Report Share Posted September 19, 2006 Will PM you. Quote Regards, Keith Rogers Zero 88 Support: support@zero88.com Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.