Jump to content
Vari-Lite Controls Support Forum

Joshua

Members
  • Posts

    6
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Joshua's Achievements

Rookie

Rookie (2/14)

  • First Post
  • Week One Done
  • One Month Later
  • Conversation Starter

Recent Badges

0

Reputation

  1. Yes, I've programmed memories 1 through 34 and the device ID is 0 (I've tried settings it to 2 and sending F0 7F 02 02 01 01 06 F7 instead but that didn't make any difference) This is the document I used when writing the command, I'm pretty sure the 00 delimiters are not needed when not sending Cue list or Cue path, I've tried 00 after the 06 but that also doesn't make any difference. Do you have download links to old versions of the jester ml software so that I can test if it works with earlier versions?
  2. Hi, I have another question regarding MSC The manual states that I can send Cue numbers as the data of the GO, TIMED_GO and LOAD commands, when I do that any Cue numbers sent are ignored (go and timed go advance to the next memory in the cue and load doesn't do anything). The sysex message I'm sending is F0 7F 00 02 01 01 06 F7 (this should activate the sixth memory in the stack). Do you know what could be the issue here? Joshua
  3. The Roland UM-One MkII just arrived and I can confirm that it works flawlessly, thank you for your great support. Joshua
  4. Thanks, I'm looking at buying the Roland UM-One MkII since I've seen this recommended a lot and I'm 99.9% sure that it will work. Do you have any experiences with that particular device?
  5. Yes, this is exactly what it looks like, I'm suspecting that it might be the issue here, when I connect the Input to the through port on the jester MIDIOX displays a constant stream of note off messages. Can you recommend any higher quality converters? I'm pretty new to midi and have no idea what to look out for.
  6. Hi, I'm trying to control the cue stack on my jester ml 48 (firmware version 4.1) via midi show control but for some reason the jester is not recognizing the msc messages. I'm sending midi notes from reaper to bome's midi translator and translating them into msc messages, those then get sent via a usb to midi converter to the jester, all of those steps work fine (the out light on the converter flashes with each sent message) but for some reason the jester is not responding to the message. The same setup works with normal midi notes so I was wondering if the msc messages need to be formatted differently than the standard but I haven't found anything about that in the manual. The message I'm trying to send is F0 7F 00 02 01 01 F7 (send GO to midi device id 00) I also tried to do the same thing from python with the same result, midi notes work but msc doesn't. Any help would be greatly appreciated ~Joshua
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.