hafashah
-
Posts
9 -
Joined
-
Last visited
Posts posted by hafashah
-
-
I’m trying to write a Fixture for chines’ moving head using the Fixture type editor,
I managed to do it all but I couldn’t find a way to write the lamp off, on reset macros
It’s available on the moving head and it’s on channel 21, help pleazzzzzzzzzzzzzzzzz
-
Jon ,
So yes done that , worked all day on it , turned it off and today tune it back on there were 1 hour delay , the console was turned off 12 hours , I notes that after updating to the latest software , but I’m not sure
-
As far as I know the disk saves shows will , and runs them will , the disk is still new a doubt that it might be a battery thing !
-
good day to all , my solution keeps changing the clock every time I turn it off and comes bake in the next day ,
Any ideas ?
-
hi. i think this is because you have (in your example) 1,2,3,4 preset sliders set to 50%, this setting is stored in the programmer, (subs and que stack will no longer alter the values) if you hit the clear button to clear the programmer then the subs will start working again. you can change the desk settings to use HTP (setup, desk setup, behavior, preset mix mode) this way what ever method has the highest value will output. however bringing the sub down completely (in your example) will only return the outputs back to 50% as the preset sliders are then the highest at 50%.
that is exactly what i'm looking for , thank you so much
-
Have same problem different case, if you have dimer faders up , let’s say 1,2,3,4 to 50% and you are using these faders with a submaster they do not respond to the submaster ,
Is there a button to hit so you can control them?
I’m trying to run live and recorded scenes .
-
that worked well , thank you
-
edit fixture in software 7.9.9
in Solution & Solution XL
Posted
in cant locate the (Edit Fixture ) in the setup menu , were can i find it , or if there is a method that i can change the Home attributes for the fixtures ?