Leaderboard

Yep, that’s the ticket.

Hi @Stan Vigurs Were you raising fixture 14's channel fader, and noticing that it was also adjusting fixture 26's intensity? If so, I would recommend testing your console's faders. To do this, switch off the console, and then switch it on with the SETUP key held down. After around half a minute, the console will boot into Test Mode, with a virtual front panel shown on the internal touchscreen. Please move each fader up and down, and check that the console is registering the level of the faders correctly. If a physical fader's level does not match the fader level the console is registering onscreen, or a physical fader activates a different fader onscreen, please let me know, and I can advise the best steps to take. To exit Test Mode, switch the console off and back on again, and it will then boot normally. Please let us know if you have any questions.

Hi @discover I will let you follow @Edward Z88's instructions first. If subsequently you need to load "user created" fixture definitions, you just load them with Setup->Load (with the IFT file(s) on a USB stick of course). Here is the entry in the English manual: https://www.zero88.com/manuals/zeros/setup/load/fixture-files-2 Good luck, I hope you get your lights working!

I have doublechecked the Shark Wash One 7-channel mode, and the Shark Zoom Wash One in 8-channel mode. As these modes do not have colour mixing, you will need to choose a colour using the "Colour Mix" parameter to achieve light output. To do this, raise the fixture's fader, tap the "Colour" tab at the top, and then press the button in the middle of the "Colour Mix" parameter's encoder wheel. This will show all of the available colours, allowing you to tap the colour you want. You can then tap the encoder's button again to close. You could then store this colour as the fixture's default colour if you wanted to, so that the next time you raise the fixture's intensity, it comes on in this colour. Please click the link below for information on customising a fixture's default parameter values... https://www.zero88.com/manuals/zeros/controlling-fixtures/defaults I hope this helps. Please let us know if you have any questions.