Leaderboard

Just an update to my previous post The IP address the message is being sent to In a typical Vision.Net system, Vision.Net commands trigger multiple different devices on the network simultaneously. It is therefore best practice to send UDP broadcast messages, that all “receivers” on the network can listen to. Using unicast is fine where there is just the one Lighting Board, as you only have a single Vision.Net “receiver”. So I prefer to specify the actual address of my LeapFrog so that the message is notpicked up by any other device on the network. With regard to the IP Address of the sending PC ZerOS dosent actually use this so it can be any value at all eg 02 02 02 02 Finally you dont need quite as many trailing Nulls you can reduce that to 24 Nulls

Hi gents, As usual programming time was very very short so I didnt end up getting exactly what I was looking for and the Chaser 1/8 sufficied in the end! I attempted using the Uni Blink effect but struggled to get it to perform as needed, im sure with a bit more fiddiling I probably would've got there. Either way, they still looked great! Pic attached for interest.