Jump to content
Zero 88 Community Support Forum
keredyelesob

odd behaviour with channels 14,16 and 33

Recommended Posts

Recently my desk has started ignoring dimmers associated with preset sliders 14,16 and 33. If i select them and use the wheels the dimmers respond. The output window also relects this behaviour. If i go to clear options and reset the desk all works again, but when i power the desk down and turn back on the same behaviour happens. The event window shows that the sliders are working fine. Any advice?

Share this post


Link to post
Share on other sites

Hi the version is 7.7

I rolled the version back months ago because V7.8 had problems when storing pre-setts (it tagged all parameters in all types of pre sets) . Also I am not keen of the order the clear button works now. I prefer the old order (memory then fixture) it would be good if this can be put in as a user option within the desk setup screens. although this is a different subject and I have already posted it into another thread Note. that has not been responded to. http://zero88.com/forum/topic/6850-zeros-7812/

 

If you would like my blank show file please let me know and i will replicate it again.

 

Many thanks

Share this post


Link to post
Share on other sites

Hi Jon, Do you have any further info on any of my quires. I currently have four open topics all have had no response. I have to say this is not the best customer care I have experienced what has happened to Zero88?

Share this post


Link to post
Share on other sites

Hi Keredyelesob,

 

Sorry for the delay in replying, however please be aware that the forum is not the place to come for instant answers - you should use our support number and support email for urgent enquiries, the forum is for discussion, and where end users can help each other out. I of course try and reply to everything as quickly as possible, but sometimes I'm not always in the office (and sometimes... I'm on holiday too!).

 

 

A showfile would definitely be useful to know why those channels aren't working.

 

Best regards

 

Jon

Share this post


Link to post
Share on other sites

I have fixed the problem by just re installing an older version of the firmware.

I do understand the forum post don't get instant replies but I see a lot of un-answered posts on here often dating back from months (very frustrating for a user). I will email from now on if that get a reply.

Thanks for your reply anyway, appreciated.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×