Jump to content
Vari-Lite Controls Support Forum

Faders and flash not responding correctly


mikkleePHS

Recommended Posts

Just started as a PA tech in a local school, in the middle of setting up a general wash and discover that several of the flash buttons don't respond. In addition, I have discovered that the faders only start responding at about 8, by then I have very little control over levels. Also, once the faders are up even the smallest vibration through the desk, be it a tap, sometimes even someone walking across the space, the lights all flicker, no matter the level they are set to. The desk we have is a Fat Frog, with no obvious damage besides cosmetic from being around school kids. Any help in the matter is much appriciated.

 

 

Update: Ok, found whats happened, but not sure how. The fader settings have been split, so Aa3 (Preset a, set a, fader 3) and Ac3 equal 1 fader, and both flash buttons have to be pressed to work. I am assuming this is what has happened with each fader now as well. Is there an easy was to fix this, or quicker to just master reset the desk? Up until today I didn't think this possible

Link to comment
Share on other sites

that sounds like an issue with the switch settings on the back of the preset PCB.

these identify which channels are being decoded.

For ch 1-12 none of the switches should be on, for ch 13-24 only number three should be on.

PM on the address below for more details.

Regards,

Keith Rogers

Zero 88 Support: support@zero88.com

Link to comment
Share on other sites

  • 3 weeks later...

Bump as still having the issue. I have tried the Dip switch fix but meant all lanterns responded to the grand master only ie, all coming on at the level of the GM. Putting the desk back at the original settings (all Dips off 000 000) I found a new problem arose in that if B master is at anything other than full, I have no control over them lanterns, but if its at full I go back to the orignal problem of 1 and 13 both having to be used so I can get full control over a single lantern. I'm more than slightly perplexed as to how this has happened, especially the problem 'evolving' as the desk is exactly as I found it first time

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.