Hi
When I upgrading it or After upgrading (although I get always the same error) I always
can enter SETUP and reset the console.
When I finish the proccess, I can add fixtures and I can schedule other things too, but
when I try to load some showfile, no matter which one, or when I try read it since a
pendrive, even before I have load and saved by PhantomJester, do not load and passed
to PRESET. From there I leave again add fixtures and the message "Out of Memory"
until I return to reset the console.
If I reload the previous version, V3.0, sometimes I get errors (eg "Error 007, Bad
Channel Size, Data 0 Count 068) and othertimes not, but let me load any of the
showfile, add fixtures and do anything else without problems.
This procedure I have repeated many times, and with version V3.3's always the same.
I have seen the warning not to upgrade to this version of consoles built before the 17th
week of 2008. The serial number is 0011400 0815XXXX mine, “Passed Test Apr 08”.
If it was manufactured before, please you notify me, although I have worked good with
later versions to V2.1.
A greeting.