Just thought I'd re-post the guide with a couple of small but important edits.
Nice...
Run Zero 88 WYSIWYG Driver 1.1 available on the cd , and select 127.0.0.1 (as you're running WYSIWYG and Phantom on the same PC) and press Okay
Open Phantom ZerOS 4.4.0 and load the Frog 2 desk.
After that, go to Setup > Network > WYSIWYG > Enable WYSIWYG (double click and select yes) > IP adress - double click and set to 127.0.0.1 > Close
Then opening WYSIWYG (Release 22) with Touring - Rock Concert template loaded (for the sake of going though this guide)
[Note: If you decide to start a WYSIWYG project from scratch instead of running a default template, you must set up your universes in WYSIWYG for that project at this point, as instructed in step 1 of lesson 10 in the WYSIWYG quick start guide available here: https://www.castgroupinc.com/cast/software/...22&DID=1044 You will also need to install the TSCC Codec available from the same page to view the guide properly]
I then go to Live > Device Manager > New > Select the Frog 2 and press Insert
Next I highlight the Frog 2 from the Device Manager and select Properties
From there I type into the address field 127.0.0.1
Then, double click Port 1 and select your first universe > double click Port 2 and Select second universe > double click Port 3 and Select your third universe > double click port 4 and select (that's right) your fourth universe
Finally, press Apply > Okay > and then highlight Frog 2 from the Device Manager and press Connect.