I have been using a Lightmaster XLS to control four analogue dimmer packs for some years, and we are moving over to DMX control (actually one DMX pack and a demux).
When I connected up, the demux and DMX pack indicated they were receiving a signal, but I could only get one channel to respond and on an unrelated dimmer. Yes - I had done a super user reset, which, as I understand it will remap the dimmer to DMX output to 1=1, 2=2, 3=3, etc. However, because of pressure of getting the show going, we had to resort to ananlogue control.
I investigated further, without time pressure. I did a super user reset again, and examined the patching (as per manual). It was all over the place and only one DMX xhannel in the range 1-24 was mapped to a dimmer channel. I then remapped channels 1-24 to their respective dimmer channels, and now everything appears fine.
So I think I have solved the problem, but I do not understand why the super user reset did not restore the default mapping, which I understand to be 1=1, etc. The procedure is to press 'GO', when 'rS' is displayed, isn't it?
Nigel